FLUE EXHAUST FAN - REAR MOUNTMULTI-FUEL CONVERSION CAPABILITY Burn WOOD PELLETS NEGATIVE DRAFT ... Eliminate HOPPER FIRES!!!
FLUE EXHAUST FAN KIT - REAR MOUNT will enable you to convert your positive-draft corn stove into a NEGATIVE DRAFT and allow you to burn multiple fuels such as wood pellets. This Kit will replace your positive draft fan inside your corn stove that pushes air and flue exhaust through the combustion chamber and out the flue exhaust pipe. Positive draft systems can push hot flue exhaust gases through the hopper bin if there is a flue exhaust pipe restriction... thus creating a HOPPER FIRE!!! Get rid of your old positive draft flue exhaust fan and replace it with this rear-mounted Flue exhaust fan. The kit comes with the fan, take-offs, wire extensions and connectors, plate-off, fresh-air take-off, fresh-air damper. Check out our other Corn Stove items listed in our Ebay Store.
FRESH AIR DAMPER VALVE adjustments can either be measured by an expensive AIR FLOW METER (or Anemometer) or it can be done manually by eye adjustment. Refine tuning is done by eye anyway. The eye adjustments are: (1) CORN BURNING: 2 turns counter clockwise with the gate valve open around 3/8 th inch. Note this opening can vary from 1-3/4 to 2-1/2 turns subject to the speed of the stove and the fullness of the firepot with ash; (2) WOOD PELLET BURNING: 3 TO 3-1/2 turns counter clockwise, again subject to the burning speed of the stove and the fullness of the firepot with ash. (Fire pots should have the ash top-skimmed out daily and the entire fire pot cleaned weekly.)
FLUE EXHAUST KIT - REAR MOUNT
- FLUE EXHAUST FAN ASSEMBLY (see first three pictures)
- Right-Angle Turn Take-off ... allow exhaust to go straight back (see first picture)
- Straight-Up Vertical Take-Off up through Chimney (see 2nd and 3rd pictures)
- Wire Extensions with End Connectors (see pictures)
- Remove Existing Fan and cover hole with Supplied PLATE COVER (see pictures)
- Fresh Air 2 inch Take-off bracket (see next to last picture)
- Entire FLUE EXHAUST KIT (see next to last picture)
- Fresh-Air DAMPER, Gate Valve (see last two pictures)
SHIPPING OR PERSONAL PICKUP Customer may have it shipped by either by USPS, Fedex, or UPS, weight with the package included is 35 lbs.
SPECIFICATIONSWeight 35 lbs, Exhaust Fan Motor 120 VAC, 1.6 Amps, 1/10 HP, 3300 RPM, 70 fpm (feet per minute), Wire 14-16 GAGE, 15 Amp Limit, Plate 1/16 Zinc-plated steel, Damper is 1-1/2 Gate Valve with a 2 inch (outside diameter) take-off Bracket.
Remember to check our Store for other related items. For questions or comments contact: Corn Stoves of Iowa, Corn and Wood Pellet Stove Dealer, 1312 1st Avenue, N.W., Cedar Rapids, IA 52405, 319-298-0500, FAX 319-362-0978, E-mail: [email protected]